Ürün Açıklaması

    This is a general OLED display Module, 1.5inch diagonal, 128x128 pixels, 16 gray scale, with embedded controller, communicating via SPI or I2C interface.

    Features:

    • 128x128 high resolution
    • 16 gray scale, better display effect
    • Supports SPI or I2C interface, configured via onboard resistor
    • Comes with development resources and manual (examples for Raspberry Pi/Jetson Nano/Arduino/STM32)

    Specifications:

    • Driver: SSD1327
    • Interface: SPI / I2C
    • Display color: White
    • Gray scale: 16
    • Resolution: 128x128 (most other competitive products are typically 128x64)
    • Viewing angle: >160°
    • Operating voltage: 3.3V / 5V
    • Dimension: 44.5 x 37 (mm)

    Interface:

    SYMBOL DESCRIPTION
    VCC Power (3.3~5V input)
    GND Ground
    DIN Data input
    CLK Clock data input
    CS Chip selection, low active
    DC Data/Command selection (high for data, low for command)
    RST Reset, low active

    There are two available drive interfaces for this OLED module: 4-wire SPI and I2C:

      BS CS DC DIN CLK
    4-wire SPI 0 Chip select Data/Command MOSI SCK
    I2C 1 NC I2C address selection SDA SCL

    Dimensions:

    Documents:

    • Wiki


    Ürün Özellikleri